Rotational

TraSys® Pioneering Water-Based Technology for the Rotational Molding Industry

Benefits

Stoner Coating & Release Systems supply the plastic rotational molding industry with the best in water-based mold release coatings. Free of alcohol and solvents, these coatings meet all existing and anticipated environmental regulations. Stoner coatings yield consistent, controlled release for maximum performance.

Rotational molders use Stoner release coatings because:

Their long life can reduce the need for frequent operator spraying

They are safe, easy to use, and work with LLDPE, LDPE, MDPE, HDPE, LXPE, PP, plastisol, and nylon

They exhibit minimal transfer of release materials to the molded product

They produce consistent parts without warpage or sticking, allowing your production to run smoothly

Stoner provides qualified, expert technical support

	TraSys® 420 MORE INFO	TraSys® 414 MORE INFO / MSDS	TraSys® 500 MORE INFO	TraSys® 715 MORE INFO	TraSys® 4000 MORE INFO
Release Type	Semi-Permanent, General-Purpose	Semi-Permanent, High Release	Semi-Permanent, General-Purpose	Semi-Permanent, Light Release	Mold Coating Flow Enhancer
Resin Carrier	Water	Water	Water	Water	Solvent
Typical Uses	Mold Internals	Part Lines, Removable Pins, High Releases	Mold Internals, Open Flame	Large Flat Surfaces, Difficulty in Containing Warpage	Resin flow enhancer, inserts, pin hole removal
Solvent Free	Yes	Yes	Yes	Yes	No
Alcohol Free	Yes	Yes	Yes	Yes	Yes
Recomm. Compat. Compounds	LLDPE, LDPE, MDPE, HDPE, XLPE, PP, Nylon, Plastisols	LLDPE, LDPE, MDPE, HDPE, XLPE, PP, Nylon, Plastisols	LLDPE, LDPE, MDPE, HDPE, XLPE, PP, Nylon, Plastisols	LLDPE, LDPE, MDPE, HDPE, XLPE, PP, Nylon, Plastisols	LLDPE, LDPE, MDPE, HDPE, XLPE, PP, Nylon, Plastisols
Apply to Mold	Warm2	Warm2	Warm2	Warm2	Warm2
Min. Cure Temp. / Min. Cure Time	132°C (270°F)3 / 5 minutes	132°C (270°F)3 / 5 minutes	132°C (270°F)3 / 5 minutes	132°C (270°F)3 / 5 minutes	132°C (270°F)3 / 5 minutes
Agitation Required	Slight	Slight	Slight	Slight	Shake can until ball breaks loose
Product Cosmetics	Satin	Satin	Satin	Satin	Satin
Appl. Frequency	Varies with Function	Varies with Function	Varies with Function	Varies with Function	Every part
Action if Frozen	Thaw, Agitate	Thaw, Agitate	Thaw, Agitate	Thaw, Agitate	N/A

1. Non-ozone depleting, noncarcinogenic solvent, No VOC content.
2. Hot to the touch; approximately 48°-60°C (120°-140°F).
3. Inner mold temperature; normally accomplished by cycling coated mold when empty.
4. Air cures rapidly on substrates at 32°-38°C (70°-100°F). Introduction of 149°C (300°F) heat after application enhances cure and prolongs durability of coating.